Oil & Gas   |   Measurement + Control Menu  
online catalog
  • "V"-Ring Seal Globe and Angle Valves for Bulk Storage Containers, Transports, Bobtails and Plant Piping A7500 Series and TA7500 Series

    Specifically designed to assure positive shut-off and long, maintenance free service life in liquid or vapor service on bulk storage containers, transports, bobtails, cylinder filling plants and plant piping.

    The high quality construction and wide variety of sizes make them highly suited for use with LP-Gas, anhydrous ammonia and in the chemical and petrochemical industries.

  • Flange Seal Globe and Angle Valves for Bulk Storage Containers, Filling Hoses and Plant Piping 7704, 7705 and 7706 Series

    Designed to assure positive shut-off and long maintenance-free service life in liquid or vapor service. Ideally suited for use on cylinder charging manifolds, truck filling hoses, bulk storage containers and plant piping.

    The high quality construction and wide variety of sizes make them highly suited for use with LP-Gas, anhydrous ammonia and in the chemical and petrochemical industries.

  • New 3" Soft Seat Back Check Valve (A3198S)

    Designed to provide protection in a container opening when desired flow is always into the container. May be used on in-line applications where flow must be limited to one direction.

  • Back Pressure Valves for Container or Line Applications (3146 Series, 3176 Series, A3186, A3187S, A3196, and A3276BC)

    Designed to provide protection of a container opening when desired flow is always into the vessel. May be used in line applications where flow must be limited to one direction.

    When used with the appropriate single check filler valve, the combination forms a double check filler valve suitable for use in filling of bulk storage tanks.

  • Flange Seal Liquid Transfer Angle Valves for Bulk Storage Containers 7550 and 7551 Series

    Designed especially for liquid transfer of LP-Gas from consumer bulk storage containers when used with a Check-Lok® or equipped with an integral excess flow valve. May also be used for vapor LP-Gas service.

    In NH3 applicator tanks they may be used as a vapor bleeder valve or as a liquid withdrawal valve when installed in a coupling with a dip pipe.

    These liquid transfer valves are equipped with an integral excess flow valve for liquid transfer directly from the tank fitting, or without an integral excess flow for LP-Gas transfer through a Check-Lok®. When equipped with an integral excess flow valve (7550PX), the valve should be mounted in a forged steel 3000 lb. half coupling. When mounted in a 1 1/4" x 3/4" NPT reducing coupling, the 3/4" female thread in this coupling must be full length - equivalent to a forged steel 3000 lb. half coupling.

    The excess flow valve will not function properly if these specifications are not met. Refer to the Warning Bulletin in the Excess Flow Valve Section of this catalog.

  • Tank Car Angle Valves for Railroad Tank Cars TA7894P

    Designed especially for transfer of LP-Gas and anhydrous ammonia in railroad tank car service.

    The combined heavyweight ductile iron castings and precision machining provide ruggedness and superior performance in working pressures up to 400 PSIG.

© 2014, Solares Florida Corporation  |  Site created by Thomas Web Solutions and Powered by Navigator Platform